Audio Specifications |
|
Load impedance range: |
>3Ω per channel (>6Ω in bridge mode) |
Output Power per channel, non-clipped: |
250W into 8Ω, 212W into 8Ω* 500W into 4Ω, 424W into 4Ω* |
Output Power bridge mode, non-clipped: |
1,000W into 8Ω, 848W into 8Ω* |
Output Power total, all channels: |
1,000W short term, 848W short term* >250W continuous, >212W continuous* |
DC offset voltage: |
<50mV |
Frequency Response (-3dB): |
<10Hz to >30kHz, any load impedance |
Frequency response accuracy 20Hz-20kHz: |
+/-1dB |
Dynamic range: |
>85dB A-Weighted |
THD+N (1kHz, 500W, 4Ω): |
less than 1% |
Voltage Gain: |
21dB to 45dB, adjustable |
Input impedance: |
10KΩ |
Maximum input voltage: |
4 Vrms |
Signal sense threshold: |
2.5mV (independent of Gain setting) |
Wake-up time: |
<0.2s (If other zones active),<2s (From all zones inactive) |
Turn-off time: |
15 minutes from last signal detected |
12V trigger input threshold: |
typically 3V (recommended input is 5-15V) |
|
|
Controls & Indicators |
|
Front panel: |
1 x Power LED (Unit active – White, Fault – Red) 1 x Network status LEDs (Network present – White, Fault – Red) 1 x Zone status LEDs (Signal present – White, Fault – Red) |
Rear panel: |
Reset button |
|
|
Connectors |
|
Input: |
1 x RCA (pair) Phono socket Analogue line in 1 x RCA Phono socket Digital line in 1 x Ethernet |
Output: |
1 x SpeakOn |
12V trigger control: |
1 x 3.5 mm jack - 12V trigger IN 1 x 3.5 mm jack - 12V trigger OUT (Maximum 100mA pass-through) |
|
|
Power |
|
Power consumption: |
<0.5W Standby, WoL disabled <0.5W Standby, WoL enabled 200W maximum average 2,800W peak |
AC supply: |
100-240V 50/60Hz |
AC inlet: |
IEC C14, switched |
|
|
Thermal |
|
Thermal dissipation: |
1.7 BTU/hr (standby) 150 BTU/hr (Idle) 850 BTU/hr (max) |
|
|
Dimensions |
|
Height: |
85 mm (3.4 in) 1U [100 mm (3.9 in) plus feet] |
Width: |
218 mm (8.6 in) |
Depth: |
323 mm (12.7 in) |
Net weight: |
3.4kg (7.5lb) |
Finish: |
Black |